DAYANG tricycle reference car design principles, from the frame structure to optimize the design, to make smaller vehicle driving vibration, lower noise, stronger stability!

As for the tricycle turn, the DAYANG tricycle with precise design on the angle of tricycle riser and fixture to ensure that steering is flexible and portable, driving at 80 yards still don’t run away, won’t pendulum!

DAYANG tricycle open the industry precedent, Innovation using the golden section method to precisely design the position of the brake linkage rod position to make sure excellent braking effect and higher safety factor. 

Electrically operated tricycle is a kind of tricycle used to pull goods or people with battery as power and motor as drive. The electric tricycle adopts tubular large capacity, left and right lining, deep discharge and traction type batteries, which can meet the requirements of continuous discharge for a long time. The batteries are normally used for two years, and the content is not reduced

The braking force of the service brake must be reasonably distributed among the axles.

1 The braking force of the service braking of motor vehicles (except two wheel, motorized tricycle scooter) must be symmetrically distributed between the left and right wheels of the same axle with respect to the longitudinal central plane of the motor vehicle.

2 The brake must have a wear compensation device. After the brake is worn, the brake clearance must be easily compensated by manual or automatic adjustment devices. The brake control device and its components as well as the brake assembly must have a certain reserve stroke. When the brake is heated to a certain extent, it shall still maintain effective braking without immediate adjustment.

The cargo box shall be installed firmly and reliably, and the breast board and floor of the cargo box shall be regular and have sufficient strength.

1、 The allowable deviation of the center plane of the front and rear wheels of the main vehicle of two wheeled motorcycles, two wheeled mopeds 、cargo box and side three wheeled motorcycles shall not exceed 10 mm.

2、Passenger cars shall be equipped with wheel guards, the rear wheels of trailers shall be equipped with mudguards, and all wheels of other motor vehicles shall be equipped with mudguards./3 Motor vehicles 3、shall be equipped with plate (frame) that can meet the requirements for plate installation. The front number plate (frame) shall be set in the middle or right side of the front (according to the direction of the motor vehicle), and the rear number plate (frame) shall be set in the middle or cargo box  left side of the back。

Three wheeled vehicles and low-speed truck shall be designed to ensure that the driving speed of the motor vehicle will not exceed the requirements of its maximum design speed in the actual use process, and the above motor vehicles with belt transmission devices shall be permanently engraved on the visible parts of the frame to indicate the pulley diameter.